Ignition System - 2.8L V6 ATQ

• Ignition System
  • Ignition system, checking
    • General notes on ignition system
    • Safety precautions
    • Technical data, ignition
    • Ignition system components, removing and installing
    • Ignition coils, checking
      • Special tools and equipment
      • Check ignition coils ( -N-, -N128- and -N158-)
      • Checking Ground (GND) supply of power output stage
      • Checking voltage supply to ignition coils
        • Notes
        • Test requirement
      • Checking activation
    • Intake Air Temperature (IAT) sensor -G42-, checking
      • Special tools and equipment
      • Test sequence
      • Checking wire connections
      • Check sensor:
      • Specified values
    • Engine speed (RPM) sensor -G28-, checking
      • Special tools and equipment
      • Test sequence
    • Engine Coolant Temperature (ECT) sensor -G62-, checking
      • Special tools and equipment
      • Test requirement:
      • Test sequence
      • Coolant temperature sensor with square connector
      • Coolant temperature sensor with oval connector
        • Notes
        • All models
    • Voltage supply for control module, checking
      • Special tools and equipment
      • Test requirements
      • Test sequence
    • Knock recognition control stop, checking
      • Notes
      • Check ignition angle retardation of the individual cylinders
        • Notes
        • Evaluation display groups 020/021/022/023/024 - ignition angle retardation
    • Knock sensors, checking
      • Special tools and equipment
      • Procedure
      • Check knock sensors
    • Camshaft Position (CMP) sensor, checking
      • Special tools and equipment
      • Checking activation
      • Checking voltage supply
      • Checking signal wire
      • Checking Ground (GND) wire
    • Checking wire connections between Camshaft Position (CMP) sensor and Engine Control Module (ECM)
      • Notes
      • Check phase position of Camshaft Position (CMP) sensor
    • Misfire recognition, checking
      • Test sequence
      • Checking misfire recognition of individual cylinders
      • Evaluation display group 014, display field 3; display group 015 and 016, display fields 1, 2 and 3