Steering And Wheel Alignment - Repair

• Electronic Chassis
  • 31 33 095 Measuring ride-level height of vehicle
  • 32 00... Carry out steering angle sensor adjustment
  • 32 00... General chassis and suspension definitions
  • 32 00... General information and definitions
  • 32 00... Identification of sport suspension
  • 32 00... Identification of suspension without label
  • 32 00... Move vehicle into normal position
  • 32 00... Moving vehicle into design position
  • 32 00... Notes
  • 32 00... Suspension assignment via optional extras
  • 32 00... Troubleshooting on the front axle / rear axle (alignment check)
    • Troubleshooting on the front axle
    • Troubleshooting on the rear axle
  • 32 00 150 Standard chassis / wheel alignment with DIN load
  • 32 00 610 Adjusting front wheel alignment (with KDS)
    • Notes
    • Installation:
  • 32 00 620 Adjusting rear axle
• Steering Gear with
  • 32 13... Design and function of recirculating ball power steering unit
    • Notes
    • Steering wheel in neutral position:
    • Steering wheel turned to right:
    • Steering wheel turned to left:
  • 32 13 006 Bleeding power steering unit
  • 32 13 060 Removing and installing power steering gear
• Steering arms, tie rod
  • 32 21... Layout of steering linkage
  • 32 21 080 Removing and installing idler arm
  • 32 21 091 Replacing idler arm bushing for idler arm
  • 32 21 231 Replacing left or right tie rod
  • 32 21 281 Replacing center tie rod
  • 32 21 501 Removing and installing pitman arm
  • 32 21 510 Adjusting pitman arm
• Steering Column
  • 32 31 003 Replacing upper section of steering column trim
  • 32 31 020 Removing and installing / replacing lower section of steering column trim
  • 32 31 070 Removing and installing or replacing (lower) steering spindle
  • 32 31 082 Removing and installing or replacing steering angle sensor
  • 32 31 090 Removing and installing complete steering column
  • 32 31 151 Replacing upper steering spindle bearing
  • 32 31 161 Replacing lower steering spindle bearing
  • 32 31 241 Replacing adjusting lever for steering column
  • 32 31 595 Dismantling and assembling complete steering column
    • Notes
    • Clamping fixture on mechanical adjustment unit
• Steering Lock
  • 32 32 001 Replacing complete steering lock
  • 32 32 050 Removing and installing or replacing steering-lock cylinder
  • 32 32 170 Removing and installing/replacing Interlock cable
• Steering Wheel
  • 32 33 000 Removing and installing steering wheel
• Steering Wheel for airbag
  • 32 34... Function
  • 32 34... Notes on scrapping BMW vehicles with gas generators (airbag system)
    • Notes
    • Gas generators that have not fired constitute a hazard (also to the environment)!
    • Firing failure
    • The components of an airbag system must always be disposed of. Such components must not be sold on as used parts.
      • Firing
  • 32 34 020 Removing and installing or replacing airbag unit
  • 32 34 510 Replacing contact ring (airbag)
  • 72 00... Safety regulations for handling airbag system components
    • Failure to comply with warnings and repair instructions may result in faulty activations and cause physical injury!
  • 72 00... Safety regulations for handling components with gas generators
    • Failure to comply with the warning notices and repair instructions for gas generator components can cause accidental deployment and result in injury and vehicle damage!
• Pump and oil supply
  • 32 13 006 Bleeding power steering unit
  • 32 41... Instructions for removing and installing ear clips
  • 32 41... Instructions for using special tool 32 4 000
  • 32 41... Layout of power steering unit components and lines
  • 32 41... Notes on hydraulic line with quick-release coupling
  • 32 41 001 Servotronic troubleshooting
  • 32 41 009 Checking function of power-steering pump
• Alignment Specifications
• Troubleshooting
  • 32 00... Troubleshooting on the front axle / rear axle (alignment check)
    • Troubleshooting on the front axle
    • Troubleshooting on the rear axle