Control Arm: Remove & Replace
WARNING: This page is about the M4 Base, 2D Convertible, Automatic DCT Trans, which is a different variant/trim than selected.
DOES NOT include alignment.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All Links,Both Sides | 6.0 | B | ||
| All Links,One Side | 3.2 | B | ||
| Camber Arm,Lower,Both | 1.6 | B | ||
| Camber Arm,Lower,One Side | 1.1 | B | ||
| Wishbone,Lower,Front,Both | 2.6 | B | ||
| Wishbone,Lower,Front,One Side | 1.4 | B | ||
| Wishbone,Lower,Rear,Both | 1.0 | B | ||
| Wishbone,Lower,Rear,One Side | 0.6 | B | ||
| Wishbone,Upper,Front,Both | 2.0 | B | ||
| Wishbone,Upper,Rear,Both | 2.0 | B | ||
| Wishbone,Upper,Rear,One Side | 1.1 | B | ||
| Combination Procedure: BALL JOINT: Replace: | ||||
| Bushing Type,Each | 0.4 | B | ||
| Combination Procedure: CONTROL ARM BUSHING: Replace: | ||||
| Each | 0.4 | B | ||