lemon-mirror:
Home >> Buick >> 2005 >> Century Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Introduction >> Repair Instructions >> Fuel Pressure Gage Installation and Removal >> Removal Procedure

Removal Procedure

  1. Place the fuel pressure gage bleed hose into an approved container and open the bleed valve to bleed fuel system pressure.
    2. Fig 1: Installing J 34730-1A To Fuel Rail
    GM736294Courtesy of GENERAL MOTORS CORP.
  2. Place a shop towel under the fuel pressure gage adaptor fitting to catch any remaining fuel spillage.
  3. Remove the J 34730-1A  from the adaptor fitting.
  4. Remove the J 34730-262  .
  5. Drain any fuel remaining in the fuel pressure gage into an approved container.
  6. Install the cap on the fuel pressure connection.
· About lemon-mirror