Removal & Installation
WARNING: This page is about the Fleetwood Brougham, 2D Coupe, 4.1L Eng VIN 4, which is a different variant/trim than selected.
TRANS ID - 200, 200-4R
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|
| | 3.2 | 2.4 | C |
| Combination Procedure: CONVERTER: Drain & Test: |
| | 0.2 | 0.2 | C |
| Combination Procedure: FLYWHEEL: Remove & Replace: |
| | 0.2 | 0.2 | C |
| Combination Procedure: FRONT PUMP (REMOVED): Overhaul: |
| | 0.6 | | B |
| Combination Procedure: FRONT PUMP BUSHING & SEAL: Remove & Replace: |
| | 0.3 | | B |
| Combination Procedure: OIL PUMP: Remove & Replace: |
| Front | | 0.7 | 0.4 | B |
| Combination Procedure: OIL PUMP SEAL: Remove & Replace: |
| Front | | 0.2 | 0.2 | B |
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: |
| | 0.1 | | C |
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: |
| | 0.6 | 0.3 | C |
| Combination Procedure: TRANSMISSION CASE: Remove & Replace: |
| | 3.2 | | A |
TRANS ID - 400, 425
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|
| | 2.8 | 2.2 | C |
| Combination Procedure: BAND: Remove & Replace: |
| Front | | 1.0 | | A |
| Rear or Both | | 1.7 | | A |
| Combination Procedure: CARRIER PINIONS: Remove & Replace: |
| Both | | 2.9 | | B |
| Output | | 2.4 | | B |
| Reaction | | 2.2 | | B |
| Combination Procedure: CONVERTER: Drain & Test: |
| | 0.2 | | C |
| Combination Procedure: DIRECT CLUTCH: Overhaul: |
| | 1.1 | | A |
| Combination Procedure: FLYWHEEL: Remove & Replace: |
| | 0.2 | 0.2 | C |
| Combination Procedure: FORWARD CLUTCH: Overhaul: |
| | 1.3 | | A |
| Combination Procedure: FRONT PUMP: Remove & Replace: |
| | 0.5 | | B |
| Combination Procedure: FRONT PUMP (REMOVED): Overhaul: |
| | 0.5 | | B |
| Combination Procedure: FRONT PUMP BUSHING & SEAL: Remove & Replace: |
| | 0.3 | | B |
| Combination Procedure: INTERMEDIATE CLUTCH PLATES: Remove & Replace: |
| | 1.1 | | A |
| Combination Procedure: INTERMEDIATE SPRAG: Remove & Replace: |
| | 1.5 | | A |
| Combination Procedure: LOW SPRAG: Remove & Replace: |
| | 2.5 | | A |
| Combination Procedure: OIL PUMP SEAL: Remove & Replace: |
| | 0.2 | | B |
| Combination Procedure: OUTPUT SHAFT: Remove & Replace: |
| | 2.2 | | B |
| Combination Procedure: PRESSURE CONTROL VALVE: Overhaul: |
| | 0.8 | | B |
| Combination Procedure: PUMP TO CASE GASKET: Remove & Replace: |
| | 0.3 | | B |
| Combination Procedure: SPEEDOMETER DRIVE GEAR: Remove & Replace: |
| | 1.4 | | B |
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: |
| | 0.1 | | C |
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: |
| | 0.6 | | C |
| Combination Procedure: TRANSMISSION CASE: Remove & Replace: |
| | 2.5 | | A |