lemon-mirror:
Home >> Cadillac >> 2014 >> XTS Base >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Wheel Alignment System >> Repair Instructions >> Rear Camber Adjustment

Rear Camber Adjustment

    Fig 1: Upper Control Arm-To-Frame Fastener
    GM2018874Courtesy of GENERAL MOTORS COMPANY
  1. If adjustment is necessary, remove rear cam bolt and nut. Replace with NEW only.
  2. Loosen the upper control arm-to-frame fastener enough to allow movement.
    NOTE:

    The frame of the vehicle is slotted, turning the cam nut will move the camber in to the designated location.

  3. Rotate the upper control arm-to-frame fastener in the direction necessary to the correct the camber measurement.
  4. Snug the upper control arm-to-frame fastener, do not tighten at this time.
  5. Re-inspect the rear camber specifications and adjust as necessary.
    6. CAUTION:

    This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

    CAUTION:

    Refer to Fastener Caution .

  6. Hold the NEW bolt and tighten the NEW upper control arm-to-frame nut.

    Tighten 

    150 (111 lb ft)

  7. Repeat the procedure for the other rear wheel.
· About lemon-mirror