Rear Toe Adjustment

NOTE:

Adjust the rear toe on each rear wheel separately.

Fig 1: Rear Suspension Adjust Link Nuts

Courtesy of GENERAL MOTORS COMPANY

Loosen the rear suspension adjust link nuts (1) and (3).
Adjust the toe by rotating the rear suspension adjust link (2) until the proper specification as been reached. Wheel Alignment Specifications

Fig 2: Crows Foot Wrench And Torque Wrench

Courtesy of GENERAL MOTORS COMPANY

NOTE:

The following steps use a 26 mm crows foot wrench attached to a torque wrench. The orientation of the crows foot to the torque wrench should be as close to in-line as possible to obtain accurate readings

Align the 26 mm crows foot wrench (1) to the torque wrench (2) as illustrated above.

CAUTION:

Refer to Fastener Caution .

Fig 3: Rear Suspension Adjust Link

Courtesy of GENERAL MOTORS COMPANY

NOTE:

Ensure the open end of the wrench (1) is on the adjust link (2) while the adjust link nuts (3) are checked with the torque wrench (4).

Using a backup wrench (1) to hold the rear suspension adjust link (2), tighten the rear suspension adjust link nuts (3) to 150 N.m (110 lb ft).
Recheck the toe setting.
If necessary, readjust the toe specifications.