Grind Complete
WARNING: This page is about the Monte Carlo Base, 3.8 9, which is a different variant/trim than selected.
Includes: Remove carbon, check surfaces for warpage, reface or replace Valves, resurface Valve Seats and clean Valve Guides. Adjust Valves (where applicable).| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 229CID Eng,Eng VIN 9,Gas, Both Heads | 11.5 | A | ||
| 231CID Eng,Eng VIN A, Both Heads | 9.9 | A | ||
| Combination Procedure: ROCKER ARM ASSEMBLY: Disassemble & Assemble: Includes: Clean and replace necessary components only. | ||||
| Both | 0.6 | B | ||
| One | 0.3 | B | ||
| Combination Procedure: ROCKER ARM STUD: Remove & Replace: | ||||
| Each Additional | 0.2 | B | ||
| One | 0.3 | B | ||
| Combination Procedure: VALVE SPRING ASSEMBLED HEIGHT: Correct: | ||||
| Per 3 Springs | 0.2 | A | ||