lemon-mirror:
Home >> Chevrolet >> 2004 >> Tracker 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.0L (Introduction) >> Repair Instructions >> Accelerator Controls Cable Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the accelerator control cable (1) from the accelerator pedal (2).
  2. Push the accelerator control cable through the bulkhead grommet.
    3. Fig 1: View Of Accelerator Pedal & Control Cable
    GM158305Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the accelerator control cable (1) from the throttle body by rotating the throttle lever (3) to wide open throttle (WOT) and removing the cable end from the slot.
  4. Loosen the accelerator control cable locknut and the accelerator control cable adjusting nut.
  5. Remove the accelerator control cable (1) from the vehicle.
    6. Fig 2: View Accelerator Control Cable & Throttle Lever
    GM55563Courtesy of GENERAL MOTORS CORP.
· About lemon-mirror