lemon-mirror:
Home >> Chevrolet >> 2018 >> Traverse L >> Repair and Diagnosis (Single Page) >> General Information >> Reset Procedures >> Programming And Setup - All Systems >> Repair Instructions >> K19 Suspension Control Module: Programming and Setup >> Replace and Program Control Module or Reprogram Control Module

Replace and Program Control Module or Reprogram Control Module

  1. Install EL-49642  SPS Programming Support Tool.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select Suspension Control Module - Programming and follow the on-screen instructions.
  4. On the SPS Supported Controllers screen, select Suspension Control Module - Configuration and follow the on-screen instructions.
  5. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
  6. With a scan tool, perform the suspension system calibration procedure, if applicable.
· About lemon-mirror