lemon-mirror:
Home >> Chevrolet >> 2018 >> Traverse L >> Repair and Diagnosis (Single Page) >> General Information >> Reset Procedures >> Programming And Setup - All Systems >> Repair Instructions >> K40D Seat Memory Control Module - Driver: Programming and Setup >> Replace and Program Control Module or Reprogram Control Module

Replace and Program Control Module or Reprogram Control Module

To program a replacement or an existing control module, perform the following procedure:

  1. Install EL-49642  SPS Programming Support Tool.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select K40D Seat Memory Control Module - Driver - Programming and follow the on-screen instructions.
  4. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
  5. Move the seat to a central, middle range position, then perform the memory store operation for memory "1", "2", and "Exit" or "3" if equipped. Refer to the Owner's Manual for storing memory seat positions.
· About lemon-mirror