Engine Assembly: Remove, Install, and Overhaul
WARNING: This page is about the Blazer LT, 2.0L Eng VIN 4, 4WD, which is a different variant/trim than selected.
Includes: Replace Rings, Main and Rod Bearings, Camshaft(s), Crankshaft and Timing Components. Remove Cylinder ridge, burnish Cylinders, grind Valves and clean and test or replace Lifters.
Includes (where applicable): Adjust Valves. DOES NOT include Pin fit or rebore and align Rods. See machine operations.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 2.0L Eng,4WD | DOES NOT include Air Conditioning System recover, evacuate and recharge. DOES NOT include wheel alignment. | 31.9 | A | |
| Combination Procedure: CRANKSHAFT POSITION SENSOR: Reset: | ||||
| Crankshaft Position Variation Learn | Includes: Additional time for use of scan tool to perform this procedure. | 0.2 | B | |
| Combination Procedure: THROTTLE BODY ASSEMBLY: Reset: | ||||
| Throttle Body Idle Air Flow Compensation Reset | Includes: Additional time for use of scan tool to perform this procedure. | 0.2 | B | |