lemon-mirror:
Home >> GMC >> 2021 >> Acadia AT4 >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> B174W Front view Camera - Windshield: Programming and Setup >> Replace and Program Front view Camera Module or Reprogram Front view Camera Module (without UGN)

Replace and Program Front view Camera Module or Reprogram Front view Camera Module (without UGN)

NOTE:

Due to continuous improvements, the on screen selections may vary from instructions below.

To program a replacement or an existing Front View Camera Module, perform the following procedure:

  1. Access the Service Programming System (SPS) and follow the on-screen instructions.
  2. On the SPS Supported Controllers screen, select B174W Front view Camera - Windshield - Programming and follow the on-screen instructions.
  3. Clear DTCs
  4. Following B174W Front view Camera - Windshield replacement and reprogramming, the module must be calibrated. Refer to Front View Camera Module Learn .
· About lemon-mirror