| Gas,4WD | Includes: R&I Front Propeller Shaft.
Includes: R&I Rear Propeller Shaft.
Includes: R&I Transmission Support.
Includes: R&I Transmission Mount.
Includes: R&I Transfer Case Assembly.
Includes: R&I Fender Liners.
Includes: R&I Starter Assembly.
Includes: R&I Catalytic Converter.
Includes: Check and adjust Transmission Fluid level with fluid temperature within parameters. | 11.1 | | C |
| Additional Procedure: TRANSMISSION ASSEMBLY: Removal & Installation: |
| Where Skid Plate interferes add | | 0.2 | | C |
| Combination Procedure: CONVERTER: Drain & Test: |
| | 0.2 | | C |
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace: |
| Rear | | 0.5 | | B |
| Combination Procedure: FLYWHEEL: Remove & Replace: |
| | 0.3 | | C |
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: |
| | 0.1 | | C |
| Combination Procedure: TORQUE CONVERTER SEAL: Remove & Replace: |
| | 0.2 | | B |
| Combination Procedure: TRANSFER CASE ASSEMBLY: Overhaul: |
| 4WD | | 4.3 | | A |
| Combination Procedure: TRANSFER CASE ASSEMBLY: Replace: |
| 4WD | Includes: Perform Relearn procedure. | 0.5 | | C |
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: |
| Includes: Transmission Programming and Calibration of Learned Parameters. | 0.8 | | C |
| Combination Procedure: TRANSMISSION OIL PUMP: Remove & Replace: |
| Gas | Includes: R&I Valve Body Assembly. | 1.6 | | B |
| Combination Procedure: TRANSMISSION OIL PUMP SEAL: Remove & Replace: |
| Gas, Torque Converter Housing with Fluid Pump | Includes: R&I Valve Body Assembly. | 1.4 | | B |