lemon-mirror:
Home >> GMC >> 2022 >> Hummer EV >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> K107 Drive Motor Control Module: Programming and Setup >> Reprogram Control Module

Reprogram Control Module

To reprogram an existing K107 Drive Motor Control Module, perform the following procedure:

  1. Access the Service Programming System (SPS) and follow the on-screen instructions.
    2. NOTE:

    The K107 Drive Motor Control Module, K107B Drive Motor Control Module 2 and K107C Drive Motor Control Module 3 will be programmed together.

  2. On the SPS Supported Controllers screen, select K107 - Drive Motor Control Module - Programming and follow the on-screen instructions.
  3. Clear DTCs after completing the Programming procedure.
  4. Perform the following SPS function:
    1. Setup - If applicable

      K107 Drive Motor Control Module and follow on-screen instructions.

  5. Clear DTCs.
· About lemon-mirror