lemon-mirror:
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Electrical >> Starter >> Starters >> Removal & Installation >> Battery Positive Cable Replacement >> Installation Procedure

Installation Procedure

  1. Install the positive battery cable.
  2. Install the positive cable to the clip on the oil pan.
  3. Install the positive cable to the starter.
  4. Install the positive cable nut. Tighten the nut to 9 N.m (80 lb in).
  5. Install the positive battery cable to the channel.
  6. Slide the channel pin into the oil pan tab.
  7. Install the positive battery cable channel bolt. Tighten the bolt to 12 N.m (106 lb in).
  8. Install the engine protection shield.
  9. Lower the vehicle.
  10. Install the positive battery cable (1) into the junction block. Tighten the nut to 9 N.m (80 lb in).
  11. Snap the junction block cover closed.
  12. Tighten the positive cable bolt at the UBEC. Tighten the bolt to 9 N.m (80 lb in).
  13. Position the UBEC lower cover.
  14. Install the UBEC cover.
  15. Connect the positive battery cable. Tighten the bolt to 17 N.m (13 lb ft).
  16. Snap the positive battery cable cap closed.
  17. Connect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE (SINGLE BATTERY) .
· About lemon-mirror