lemon-mirror:
Home >> Hummer >> 2005 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Introduction >> Repair Instructions >> Fuel Hose/Pipes Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Fuel Sender & Fuel Pressure Sensor Electrical Connectors
    GM863091Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps from the fuel pipes.
  2. Connect the rear fuel feed pipe and the rear fuel return pipe to the fuel sender and the fuel tank clips.
  3. Install the fuel tank. Refer to Fuel Tank Replacement .
· About lemon-mirror