Test Description

The numbers below refer to the step numbers on the diagnostic table.

2: Listen for an audible click when the automatic transmission shift lock control solenoid operates. Command both the ON and OFF states. Repeat the commands as necessary.
3: Tests the control circuit of the automatic transmission shift lock control solenoid.

DTC B2708

Step	Action	Yes	No
Schematic Reference: Shift Lock Control Schematics Connector End View Reference: Shift Lock Control Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, command the brake to shift relay output control ON and OFF. Does the automatic transmission shift lock control solenoid turn ON and OFF with each command?	Go to Testing for Intermittent Conditions and Poor Connections	Go to Step 3
3	Test the control circuit of the automatic transmission shift lock control solenoid for a short to battery voltage. Did you find and correct the condition?	Go to Step 6	Go to Step 4
4	Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 6	Go to Step 5
5	Replace the BCM. Refer to Control Module References for replacement, setup and programming. Did you complete the replacement?	Go to Step 6	-
6	Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. Does the DTC reset?	Go to Step 2	System OK