lemon-mirror:
Home >> Hyundai >> 2013 >> Elantra GLS, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System >> Injector >> Repair procedures >> Removal

Repair procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Release the residual pressure in fuel line (Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE " ).
    CAUTION: When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of "Release Residual Pressure in Fuel Line" work.
  3. Disconnect the injector connector (A).
  4. Disconnect the fuel feed tube quick-connector (B).
  5. Remove the installation bolt (C), and then remove the delivery pipe & injector assembly from the engine.
    Fig 1: Injector Connector, Fuel Feed Tube Quick-Connector And Installation Bolt
    G10234911Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the fixing clip (A), and then separate the injector from the delivery pipe.
    Fig 2: Fuel Injector Fixing Clip
    G10234912Courtesy of HYUNDAI MOTOR AMERICA
· About lemon-mirror