Removal and Installation

[LH] 

1. Disconnect the battery negative terminal.
2. Remove the engine cover.
3. Disconnect the LH ignition coil connectors (A) and then remove the LH ignition coils.

   Tightening torque: 

   9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~8.7 lb-ft)

   Fig 1: LH Ignition Coil Connectors

   Courtesy of HYUNDAI MOTOR AMERICA
   NOTE: When disconnecting the ignition coil connector, pull out the locking pin (A) and then pull out the connector while pressing the clip (B).
   Fig 2: Pulling Out Locking Pin

   Courtesy of HYUNDAI MOTOR AMERICA
4. Installation is reverse order of removal.

[RH] 

1. Disconnect the battery negative terminal.
2. Remove the surge tank.

   (Refer to "SURGE TANK ")

3. Disconnect the RH ignition coil connectors (A) and then remove the RH ignition coils.

   Tightening torque: 

   3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

   Fig 3: RH Ignition Coil Connectors

   Courtesy of HYUNDAI MOTOR AMERICA
   NOTE: When disconnecting the ignition coil connector, pull out the locking pin (A) and then pull out the connector while pressing the clip (B).
   Fig 4: Pulling Out Locking Pin

   Courtesy of HYUNDAI MOTOR AMERICA
4. Installation is reverse order of removal.