Repair procedures: Removal
NOTE:
When replacing the ECM, the vehicle equipped with the immobilizer must perform the procedure below.
In the case of installing used ECM
- Perform "ECM Neutral mode" procedure with GDS.
(Refer to "IMMOBILIZER SYSTEM ")
- After finishing "ECM Neutral mode", perform "Key teaching" procedure with GDS.
(Refer to "IMMOBILIZER SYSTEM ")
In the case of installing new ECM
Perform "Key teaching" procedure with GDS.
(Refer to "IMMOBILIZER SYSTEM ")
NOTE:
When replacing the ECM, the vehicle equipped with the smart key system (Button start) must perform the procedure below.
In the case of installing used ECM
- Perform "ECM Neutral mode" procedure with GDS.
(Refer to "IMMOBILIZER SYSTEM ")
- After finishing "ECM Neutral mode", insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.
In the case of installing new ECM
Insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Remove the cover.
- Disconnect the ECM connector (A).
- Remove the battery tray.
(Refer to "BATTERY ")
- Remove the ECM bracket installation bolts (A) and nut (B).
- Remove the air cleaner assembly.
(Refer to "AIR CLEANER ")
- After removing the installation bolts (A), remove the ECM (B) from the bracket.