lemon-mirror:
Home >> Infiniti >> 2007 >> QX56 AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Component Testing >> ASCD Brake Switch >> Component Inspection >> Stop Lamp Switch

Stop Lamp Switch

  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check harness continuity between stop lamp switch terminals 3 and 4 under the following conditions.
    TERMINALS CONTINUITY CHART

    Condition Continuity
    Brake pedal: Fully released Should not exist.
    Brake pedal: Slightly depressed Should exist.

    If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL ", and perform step  3 again.

    Fig 1: Checking Continuity Between Stop Lamp Switch Terminals 1 And 2
    G04920629Courtesy of NISSAN NORTH AMERICA, INC.
· About lemon-mirror