lemon-mirror:
Home >> Kia >> 2003 >> Spectra Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System & Component Testing >> Engine Sensors & Switches >> Throttle Position Sensor >> Sedona

Throttle Position Sensor: Sedona

  1. Turn ignition off. Disconnect TP sensor 4-pin harness connector. Measure resistance at component side between connector terminals No. 1 and 4. See Figure. With throttle fully closed, resistance should be 3.5-6.5 k/ohms. If resistances are as specified, go to next step. If resistances are not as specified, Adjust or replace TP sensor as necessary.
  2. Connect TP sensor connector. Turn ignition on. Backprobe and measure voltage between TP sensor connector terminals No. 2 (Red/Green wire) and No. 4 (Black/Yellow wire). See Figure. With throttle fully closed voltage should be .3-.9 volts. With throttle wide open, voltage should be 4.0-4.6 volts. If voltages are not as specified, Adjust or replace TP sensor as necessary.
· About lemon-mirror