lemon-mirror:
Home >> Kia >> 2009 >> Optima EX, 2.7 4 >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> SRSCM >> SRS Control Module (SRSCM) >> Repair Procedures >> Installation

Repair Procedures: Installation

  1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  2. Remove the ignition key from the vehicle.
  3. Install the SRSCM with the SRSCM mounting nuts.

    Tightening torque 

    : 1.0 ~ 1.4 kgf.m (10.2 ~ 13.8 Nm, 7.5 ~ 10.2 lb.ft)

    NOTE: Use new mounting nuts when replacing the SRSCM after a collision.
  4. Connect the SRSCM harness connector.
  5. Install the heater ducts and floor console. (Refer to FLOOR CONSOLE REPLACEMENT )
  6. Connect the DAB, PAB, SAB, CAB and BPT connectors.
  7. Reconnect the battery negative cable.
  8. After installing the SRSCM, confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
· About lemon-mirror