lemon-mirror:
Home >> Kia >> 2010 >> Rio Base >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Restraint System >> Front Impact Sensor (FIS) >> Repair procedures >> Installation

Repair procedures: Installation

CAUTION:
  • Be sure to install the harness wire not to be pinched or interfere with other parts.
  • Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
  1. Install the new Front Impact Sensor with bolt then connect the SRS harness connector to the Front Impact Sensor.

    Tightening torque

    : 1.0 ~ 1.4 kgf.m (9.5 ~ 13.5 Nm, 7.0 ~ 10.0 lb.ft)

  2. Install the front bumper. (LH)
  3. Reconnect the negative battery cable.
  4. After installing the Front Impact Sensor, confirm proper system operation: Turn the ignition switch ON the SRS indicator light should be turned on for about six seconds and then go off.
· About lemon-mirror