Idle Stop & Go (ISG) System - 1.6L

• Description and Operation
  • Description
  • Operation
  • Operation Condition for the ISG function
    • Auto stop or Auto start condition (If all of the below condition are satisfied)
    • Forced re-start conditions (If any of the below condition is not satisfied)
    • Restriction conditions for Auto-Stop operation
    • Restriction condition for auto Re-Start operation
    • Restriction condition for OBD Check & Emission control
• Troubleshooting
  • Notes
  • Battery sensor and calibration value inspection
  • Battery status inspection
  • Current Data
• Repair procedures
  • Battery Sensor Recalibration Procedure
  • Battery Refresh Logic (Partial SOC) Release Procedure
• Components and Components Location
  • Components Location
• Battery Sensor
  • Description and Operation
    • Description
• Brake Booster Vacuum Pressure Sensor
  • Description and Operation
    • Description
  • Schematic Diagrams
    • Circuit Diagram
  • Repair procedures
    • Inspection
• AGM Battery
  • Description and Operation
    • Description
    • Recharging ISG Type
      • Check the battery condition
      • Recharging the AGM battery
  • Components and Components Location
    • Components
  • Repair procedures
    • Removal and Installation
    • Inspection
      • Battery Diagnostic Flow
      • Vehicle parasitic current inspection
    • Cleaning
• DCDC Converter
  • Description and Operation
    • Description
  • Components and Components Location
    • Component Location
  • Schematic Diagrams
    • Circuit Diagram
      • 200W
      • 400W
  • Repair procedures
    • Removal
      • 200W
      • 400W
    • Installation
• ISG OFF Switch
  • Description and Operation
    • Description
  • Repair procedures
    • Inspection
• Alternator
  • Description and Operation
    • Description
    • Alternator Management System
  • Specification
  • Repair procedures
    • On-vehicle Inspection
    • Check The Battery Terminals And Fuses
    • Inspect Drive Belt
    • Drive belt tension measurement and adjustment
      • Belt tension measurement
      • Using a mechanical tension gauge (BT-33-73F, BTG-2 type)
      • Using a sonic tension meter (U-505/507 type)
    • Visually Check Alternator Wiring And Listen For Abnormal Noises
    • Check Discharge Warning Light Circuit
    • Inspect Charging System
      • Voltage Drop Test Of Alternator Output Wire
      • Preparation
      • Test
      • Result
      • Output Current Test
      • Regulated Voltage Test
    • Removal and Installation
• Starter
  • Description and Operation
    • Description
  • Repair procedures
    • Removal and Installation
• Electric Oil Pump
  • Description and Operation
    • Description
  • Schematic Diagrams
    • Circuit Diagram
  • Repair procedures
    • Removal
    • Installation
• Oil Pump Unit (OPU)
  • Schematic Diagrams
    • Oil Pump Unit (OPU) Connector
      • Notes
      • Opu Connector Terminal Function
    • Circuit diagram
  • Repair procedures
    • Removal
    • Installation
    • Inspection
      • OPU Problem Inspection Procedure
• Brake Switch
  • Description and Operation
    • Description
  • Repair procedures
    • Inspection
    • Removal
    • Installation
• Door Switch
  • Description and Operation
    • Description
  • Repair procedures
    • Inspection
    • Removal
    • Installation
• Seat Belt Switch
  • Description and Operation
    • Description
  • Repair procedures
    • Inspection
    • Removal
    • Installation
• Hood switch
  • Description and Operation
    • Description
  • Repair procedures
    • Inspection
    • Removal
    • Installation