Repair Procedures: Adjustment
- After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If installing a used ECM]
- Perform "ECM Neutral Mode" procedure using GDS. (Refer to "Body Electrical System - "Immobilizer System - NEUTRALIZING OF ECM ")
- After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using GDS. (Refer to "Body Electrical System - "Immobilizer System - TEACHING PROCEDURES ")
[If installing a new ECM]
Perform "Key Teaching" procedure using GDS. (Refer to "Body Electrical System - "Immobilizer System - TEACHING PROCEDURES ")
- After replacing the ECM of the vehicle with the smart key system (button start), the following procedure must be performed.
[If installing a used ECM]
- Perform "ECM Neutral Mode" procedure using GDS. (Refer to NEUTRALIZATION STATUS CHECK )
- After finishing "ECM Neutral Mode", turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
[If installing a new ECM]
Turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
- Perform TCM learning after replacing the PCM. (Refer to Automatic Transaxle Control System - "ADJUSTMENT ")