Anti-Lock Brake System
- Description
- Operation
- Bleeding Brake System
- Trouble Shooting
- Pre-Diagnosis Inspection
- Diagnosis & Testing
- Diagnostic Trouble Code Testing
- * Please Read First *
- Abs-1: One Flash Should Not Occur
- Abs-2: Open Isolation Solenoid Circuit
- Abs-3: Open Dump Solenoid Circuit
- Abs-4: Solenoid Valve Switch Closed
- Abs-5: System Dumps Too Many Times; Condition Occurs While Making Normal Or Hard Stops, Rear Brake May Lock
- Abs-6: Speed Sensor Signal Rapidly Cuts In & Out; Condition Only Occurs While Driving
- Abs-7: Shorted Isolation Solenoid Ground Circuit
- Abs-8: Shorted Dump Solenoid Ground Circuit
- Abs-9: High Speed Sensor Resistance
- Abs-10: Low Speed Sensor Resistance
- Abs-11: Stoplight Switch Always Closed Or Stoplight Switch Circuit Defective; Condition Indicated Only When Driving Faster Than 35 Mph
- Abs-12: Decrease In Brake Fluid Pressure
- Abs-13: Abs Control Module Speed Circuit Phase Lock Loop Failure Detected During On-Board Diagnostic Test
- Abs-14: Abs Control Module Program Check Sum Failure Detected During On-Board Diagnostic Test
- Abs-15: Abs Control Module Ram Failure Detected During On-Board Diagnostic Test
- Component Testing
- Removal & Installation
- Adjustments
- Torque Specifications
- Wiring Diagrams