lemon-mirror:
Home >> Mazda >> 2006 >> MPV ES >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Throttle Position (TP) Sensor Inspection >> Resistance Inspection

Resistance Inspection

  1. Verify that the throttle valve is at CTP.
  2. Inspect accelerator cable free play. (See ACCELERATOR CABLE INSPECTION .)
  3. Measure the resistance between TP sensor terminals A and C using an ohmmeter.
    • If not as specified, replace the TP sensor.
    • If as specified, but PID value or PCM terminal 40 voltage are out of specification, perform the "CIRCUIT OPEN/SHORT INSPECTION ".

    Specification 3.2-4.8 kilohms 

    Fig 1: Identifying TP Sensor Connector
    G04328330Courtesy of MAZDA MOTORS CORP.
· About lemon-mirror