Function Inspection
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PID FUEL_PRES. (See On-board Diagnostic Test .) (See PCM Inspection .)
- Compare the voltage and fuel value indications for the PID FUEL_PRES with the standard in the table indicated below.
- If they do not match the standard, perform the voltage inspection. (See VOLTAGE INSPECTION .)
VOLTAGE SPECIFICATION - STANDARD
| FUEL_PRES | |
|---|---|
| V | MPa {kgf/cm2 , psi} |
| Approx. 0.79 | 3.0 {31, 435} |
| Approx. 0.96 | 4.8 {49, 696} |