lemon-mirror:
Home >> Mercedes Benz >> 1990 >> 190E Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Fuel System >> Lambda Control (Federal Models) Test

Lambda Control (Federal Models) Test

  1. Connect On-Off Ratio Tester (KDJE-P 600) to vehicle. Unplug oxygen sensor. Run engine until operating temperature is reached. Read and record voltage on tester with engine idling. Reconnect O2 sensor. Push 12-volt button on tester.
  2. Set engine speed to 2000 RPM. If engine is at operating temperature, voltage reading should not vary from previously recorded voltage by more than 0.8 volt. If reading is correct, lambda control is working and test is complete.
· About lemon-mirror