lemon-mirror:
Home >> Mitsubishi >> 2006 >> Raider XLS, RWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine And Emission Control >> Cable - Speed Control >> Installation >> 3.7/4.7L Engines

3.7/4.7L Engines

  1. Install end of cable to speed control servo. (Refer to INSTALLATION )
  2. Slide speed control cable plastic mount into throttle body bracket.
  3. Install speed control cable connector onto throttle body bellcrank pin (push rearward to snap into location).
  4. Slide throttle (accelerator) cable plastic mount into throttle body bracket. Continue sliding until cable release tab is aligned to hole in throttle body mounting bracket.
  5. While holding throttle to wide open position, place throttle cable pin into throttle body bellcrank.
  6. Install air intake tube to top of throttle body.
  7. Connect negative battery cable at battery.
  8. Before starting engine, operate accelerator pedal to check for any binding.
· About lemon-mirror