Engine Assembly: Remove, Install, and Overhaul
WARNING: This page is about the Sunfire SE, 2D Convertible, 2.2 4, Automatic, which is a different variant/trim than selected.
Includes: Replace Rings, Main and Rod Bearings, Camshaft(s), Crankshaft and Timing Components. Remove Cylinder ridge, burnish Cylinders, grind Valves and clean and test or replace Lifters.
Includes (where applicable): Adjust Valves. DOES NOT include Pin fit or rebore and align Rods. See machine operations.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 2.2L Eng,Automatic Trans | 21.5 | A | ||
| Additional Procedure: ENGINE ASSEMBLY: Remove, Install, and Overhaul: | ||||
| Where Air Cond interferes add | 1.3 | A | ||
| Where Cruise Control interferes add | 0.2 | A | ||
| Where Pwr Strg Interferes add | 0.4 | A | ||
| Combination Procedure: CAMSHAFT BEARING: Remove & Replace: | ||||
| 2.2L Eng, Each | 0.3 | A | ||
| Combination Procedure: VALVE SPRING ASSEMBLED HEIGHT: Correct: | ||||
| Per 3 Springs | 0.2 | A | ||