lemon-mirror:
Home >> Pontiac >> 2005 >> Aztek Base, FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.4L - Introduction >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of MAP Sensor
    GM54360Courtesy of GENERAL MOTORS CORP.
  1. Position the MAP sensor to the bracket.
  2. Connect the MAP inlet vacuum hose.
  3. Connect the MAP sensor electrical connector.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the screws.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

· About lemon-mirror