lemon-mirror:
Home >> Pontiac >> 2005 >> Sunfire Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.2L - Introduction >> Repair Instructions >> Knock Sensor (KS) Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View of Knock Sensor
    GM630342Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: The KS threaded surfaces must be clean before installation.
  1. Install the knock sensor.

    Tighten:  Tighten the knock sensor retaining bolt to 25 N.m (18 lb ft).

  2. Connect the knock sensor harness connector.
  3. Install the starter. Refer to Starter Motor Replacement in Engine Electrical.
· About lemon-mirror