Modify coding
Under the menu item "Modify coding" you can adapt the wiper motor control module to the current vehicle equipment.
After the wiper motor with control module is replaced, the coding must be adapted to the vehicle equipment so that the control module knows which sensor it can find on the sensor cable.
The following equipment features can be changed:
- Wiper with rain sensor
- Wiper with rain/light sensor
Vehicle coding table
VEHICLE CODING CHART
| Setting | Function |
|---|---|
| Rain sensor | Automatic intermittent wiper operation |
| Rain/light sensor | Automatic intermittent wiper operation and headlight control |
NOTE:
- When the coding is changed in the menu item "Modify coding", the ignition must always be switched off afterwards and the key removed.
- After the ignition is switched on again, the new coding of the control module is updated and the stored faults can be erased.
- If it is not possible to communicate with the wiper motor control module in the headlight, this may be caused by incorrect coding. Remedy: Re-code the control module and restart connection setup using the Tester. Code control module correctly.
NOTE:
- If the coding does not match the vehicle equipment, faults will be displayed that are not really present.
- The wiper motor control module does not function without a valid coding entry.