Grind Complete
WARNING: This page is about the XT DL, which is a different variant/trim than selected.
Includes: R&I Engine Assembly (where noted). Remove carbon, check surfaces for warpage, reface or replace Valves, resurface Valve Seats, clean Valve Guides, adjust Valves.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Normally Aspirated, Both | 10.8 | A | ||
| Additional Procedure: VALVE: Grind Complete: | ||||
| Refer to Additional Times following Cylinder Head Gasket - R&R. | A | |||
| Combination Procedure: CYLINDER HEAD STUD: Remove & Replace: | ||||
| Each | 0.1 | B | ||
| Combination Procedure: VALVE GUIDE: Remove & Replace: | ||||
| Each Additional | 0.2 | A | ||
| One | 0.3 | A | ||