Air Cleaner Element: Replacement

Disconnect the ground cable from battery.

Fig 1: Disconnecting Ground Cable From Battery
Disconnect the connector from mass air flow sensor.
- Non-turbo model
  
  Fig 2: Locating Connector From Mass Air Flow Sensor - Non-Turbo Model
- Turbo model
  
  Fig 3: Locating Connector From Mass Air Flow Sensor - Turbo Model
Loosen the clamps (A) which connect the air cleaner case to intake duct. (Turbo model)
Remove the clips (B) on air cleaner case.
- Non-turbo model
  
  Fig 4: Identifying Clamps
- Turbo model
  
  Fig 5: Locating Clamps - Turbo Model
Remove the air cleaner case (rear).
Remove the air cleaner element.

Fig 6: Removing Air Cleaner Element
Install in the reverse order of removal.
NOTE:
- Fasten with a clip after inserting the lower tab of case.
  
  Fig 7: Locating Lower Tab Of Case
- Refer to "COMPONENT" for tightening torque. 2.5 L non-turbo model
  < Ref. to COMPONENT , General Description. > 2.5 L turbo model
  
  < Ref. to COMPONENT , General Description. > 3.0 L model
  
  < Ref. to COMPONENT , General Description. >