lemon-mirror:
Home >> Subaru >> 2012 >> Outback Limited >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Continuously Variable Transmission >> Transmission Mounting System >> Removal

Transmission Mounting System: Removal

  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle.
  3. Remove the center exhaust pipe. Refer to CENTER EXHAUST PIPE EX(H4SO)-7, REMOVAL, Center Exhaust Pipe.
  4. Remove the heat shield cover.
    Fig 1: Identifying Heat Shield Cover
    G06651705Courtesy of SUBARU OF AMERICA, INC.
  5. Set the transmission jack under the transmission. Make sure that the support plate of transmission jack does not touch the oil pan.
  6. Remove the transmission rear crossmember.
    Fig 2: Locating Transmission Rear Crossmember Mounting Bolts
    G06654383Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the rear cushion rubber.
    Fig 3: Locating Rear Cushion Rubber Mounting Bolts (View 1 Of 2)
    G07913367Courtesy of SUBARU OF AMERICA, INC.
· About lemon-mirror