Camshaft Position Sensor: Installation: Exhaust

RH SIDE
1. Install the camshaft position sensor with new O-ring.
  NOTE: Apply engine oil to O-ring.
  
  Tightening torque:
  
  6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
2. Connect the connector.
3. Install the under cover front. Refer to EXTERIOR/INTERIOR TRIM>Front Under Cover>INSTALLATION .
4. Lower the vehicle.
5. Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
LH SIDE
1. Install the camshaft position sensor with new O-ring.
  NOTE: Apply engine oil to O-ring.
  
  Tightening torque:
  
  6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
2. Connect the connector.
3. Install the under cover front. Refer to EXTERIOR/INTERIOR TRIM>Front Under Cover>INSTALLATION .
4. Lower the vehicle.
5. Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .