Transmission - Installation
- Transmission
- Transaxle, Installing
- Notes
- Installing the Transmission
- Adjusting the Position Of the Engine And Gearbox
- Installing And Tightening Screws For the Transmission
- Fitting the Torque Converter Screws.
- Lifting the engine/gearbox
- Installing the Rear Engine Mounting
- Installing the Bevel Gear
- Installing the Bracket
- Installing the Lower Charge Air Pipe
- Installing Oil Pipes To the Transmission
- Installing the Left Drive Shaft On the Transmission And the Wheel Spindle
- Fitting the Sub-Frame To the Body
- Installing the Right-Hand Drive Shaft To the Gearbox, Wheel Spindle And Link Arm
- Tightening the sub-frame screws (both sides)
- Installing the Screws For Engine Pads And the Torque Rod Bracket In the Transmission
- Installing the steering wheel shaft joint
- Installing the collision protection system over the steering gear
- Installing the crossmembers
- Installing and tightening front suspension components
- Installing the cable conduit
- Removing the lifting beam
- Installing the water hose
- Installing Screws For The Transmission/Starter Motor
- Installing Gear Selector Cable
- Installing Engine Compartment Components
- Finishing
- Tightening Torque
- Transaxle, Installing