lemon-mirror:
Home >> Acura >> 1991 >> Integra LS, 2D Hatchback, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Controls - Adjustments >> Ignition Timing

Ignition Timing

  1. Run engine until cooling fan comes on. Locate Light Gray connector at right side (under dash), next to blower motor. Connect terminals of the ignition timing adjusting connector with a jumper wire. See Fig 1 .
  2. Red mark on crankshaft pulley should align with pointer. See Fig 2 . If Red mark and pointer are not aligned, adjust base ignition timing by turning distributor. See IGNITION TIMING  table. Remove jumper wire from ignition timing adjusting connector.
    Fig 1: Locating Ignition Timing Adjusting Connector
    G90A04362Courtesy of AMERICAN HONDA MOTOR CO., INC.
    Fig 2: Locating Ignition Timing Marks
    G61026Courtesy of AMERICAN HONDA MOTOR CO., INC.
    IGNITION TIMING

    Application Degrees BTDC @ RPM
    Manual Transmission 14-18 @ 700-800
    Automatic Transmission (1) 14-18 @ 700-800
    (1) Automatic transaxle in Neutral.
· About lemon-mirror