Low Fuel Indicator
- Park vehicle on level surface. Drain fuel tank into an approved container. Using a new washer, install fuel tank drain plug. Add less than 2.2 gallons (8.2 liters) of fuel to fuel tank. Turn ignition on. If low-fuel indicator does not illuminate within 4 minutes, go to next step. If low-fuel indicator illuminates within 4 minutes, add approximately 1.1 gallon (4 liters) more fuel to fuel tank. If low-fuel indicator goes out within 4 minutes, system is operating properly. If indicator does not go out, go to next step.
- Remove rear seat and fuel pump access panel. Turn ignition off. Disconnect fuel gauge sending unit 3-pin connector. Connect a jumper wire between connector Black/White wire and Blue/White wire. If low-fuel indicator illuminates, check sending unit or ground connection. If low-fuel indicator does not illuminate, check for open in Blue/White wire, no voltage to gauge assemble or a blown bulb. See WIRING DIAGRAMS . Repair as necessary.