lemon-mirror:
Home >> Acura >> 1997 >> NSX 3.2 NA2 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System & Component Testing >> Variable Valve Timing >> VTEC Spool Valve

VTEC Spool Valve

  1. Disconnect the 2 pin connector from the spool valve.
  2. Measure resistance between the Blue/Yellow terminal and body ground. Resistance should be approximately 14-30 ohms. See Fig 1 .
  3. If the resistance is within specifications, remove the spool valve assembly from the cylinder head and check the spool valve filter for clogging. If there is clogging, replace the engine oil filter and engine oil. See Fig 2 .
  4. If filters are normal, push the spool valve with your finger and check its movement. If spool valve is normal, check the engine oil pressure. See Fig 3 .
Fig 1: Testing VTEC Spool Valve Resistance
G00125729Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 2: Inspecting VTEC Spool Valve
G00125721Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 3: Testing VTEC Spool Valve Operation
G00125722Courtesy of AMERICAN HONDA MOTOR CO., INC.
· About lemon-mirror