Gearshift Lever Position Indicator Input
- Remove instrument cluster. See INSTRUMENT CLUSTER
under REMOVAL & INSTALLATION. Disconnect instrument cluster 30-pin connector "A" and 14-pin connector "C". Inspect connectors and terminals. Check for bent, loose or corroded terminals. Perform gearshift lever position indicator input test "A". See Fig 1
. Repair as necessary and recheck system operation. If gearshift lever position indicator inputs are okay, go to next step.
- Reconnect instrument cluster 30-pin connector "A" and 14-pin connector "C". Perform input test "B" as specified at back side of instrument cluster (backprobe). See Fig 1
. Repair as necessary. If no problems are found, replace instrument cluster printed circuit board and recheck system.
Courtesy of AMERICAN HONDA MOTOR CO., INC.