Keyless Buzzer Test/Replacement

Remove the left inner fender (see FRONT INNER FENDER REPLACEMENT ).
Disconnect the 2P connector (A) from the keyless buzzer (B).

Fig 1: Disconnecting 2P Connector From Keyless Buzzer
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Test the buzzer by checking the resistance across the No. 1 and No. 2 terminals. There should be about 1.7 kΩ.
If the buzzer is not within the specification, remove the two mounting screws, then replace the buzzer (A).

Fig 2: Removing Buzzer
Courtesy of AMERICAN HONDA MOTOR CO., INC.