Ignition Switch/Steering Lock: Test

SRS components are located in the area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before performing repairs or servicing.

1. Do the battery terminal disconnection procedure (See DISCONNECTION .
2. Remove the steering column covers (see COLUMN COVER REMOVAL/INSTALLATION ).
3. Disconnect the 7P connector (A) from the ignition switch (B).
   Fig 1: Identifying 7P Connector And Ignition Switch

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Check for continuity between the terminals in each switch position according to the table.
   Fig 2: Switch Position Terminals Continuity Chart

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. If the continuity does not agree with the table, replace the ignition switch (see REPLACEMENT  ).
6. Do the battery terminal reconnection procedure (See RECONNECTION ).