Engine Oil Replacement

Warm up the engine
Remove the drain bolt (A), and drain the engine oil

Fig 1: Drain Bolt With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Reinstall the drain bolt with a new washer (B)
Refill with the recommended oil (see LUBRICANTS AND FLUIDS )
Capacity

At Oil Change

4.0 L (4.2 US qt)

At Oil Change including Filter

4.3 L (4.5 US qt)

After Engine Overhaul

5.0 L (5.3 US qt)

Fig 2: Filling Engine Oil In Engine
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Run the engine for more than 3 minutes, then check for oil leakage
If the maintenance minder required engine oil replacement, reset 1 he maintenance minder (see MAINTENANCE MINDER ), and this procedure is complete If the maintenance minder did not require engine oil replacement, go to step 7
Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode
Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 on GENERAL TROUBLESHOOTING INFORMATION )
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode
Make sure the HDS communicates with the vehicle and the powertrain control module (PCM) If it does not communicate, troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING )
Select GAUGES in the BODY ELECTRICAL with the HDS
Select ADJUSTMENT in the GAUGES with the HDS
Select MAINTENANCE MINDER in the ADJUSTMENT with the HDS
Select RESET in the MAINTENANCE MINDER with the HDS
Select RESETTING THE ENGINE OIL LIFE with the HDS
NOTE: If you changed the ATF at the same time with the engine oil, select RESETTING THE ENGINE OIL LIFE AND ATF with the HDS instead