Security Hood Switch Test

Open the hood then remove the bulkhead cover (see FRONT BULKHEAD COVER REPLACEMENT ).
Remove the cover (A), and disconnect the 2P connector (B) from the security hood switch (C).

Fig 1: Identifying Cover And Security Hood Switch 2P Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each switch position according to the table.

Fig 2: Security Hood Switch Continuity Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity is not as specified, the security hood switch is faulty; replace the hood latch (see HOOD LATCH REPLACEMENT ).