VSA Sensor Neutral Position Memorization: Procedure

How to use this manual .

NOTICE: 

The VSA sensor neutral position must be learned whenever you do any of these actions:

• Updating or replacing the VSA modulator-control unit.
• Removing the steering wheel.
• Disconnecting the steering joint.
• Wheel alignment adjustment.
• Updating or replacing the SRS unit.

1. VSA Sensor Neutral Position - Memorize

   Preconditions 

   • Do a wheel alignment .
     NOTE:

     • Keep the vehicle on the alignment rack even after adjustment and make sure the turning pads are locked.
     • Remove the steering wheel holder and make sure the steering wheel is in the straight ahead position.
   • HDS Connected

   Procedure 

   NOTICE: 

   Do not press the brake pedal during this procedure.

   • Select the following menu buttons on the HDS screen in sequence.
     1. ABS/VSA (System Selection Menu)
     2. ADJUSTMENT
     3. ALL SENSOR
        NOTE: At the final step when returning the steering wheel to the center position, make sure to turn the wheel until the total toe on the alignment reading reaches zero.
   • Test drive the vehicle with minimal road crown and make sure the vehicle tracks straight with the steering wheel point straight ahead with little to no resistance.